FLOW RACKS INSTALLATION
WELCOME TO OUR INSTALL GUIDE
VERTICAL PLACEMENT
A curved bracket on each side and the base plate below the surfboard.
HORIZONTAL PLACEMENT
Two curved brackets on underside of the side of the surfboard and the base place at the top.
✅ Line up and pre-drill the wall first, then handscrew in place the transparent brackets with the supplied screws and covers.
1. Choose the board you wish to display and ensure all mounting holes are into structural supports like timber or brick.
2. Using a pencil mark on the proposed wall mounting locations.
3. (Optional) Pre-drill a small hole into the wall in each location.
4. Line up each transparent bracket with the drilled wall hole. Put the supplied screw through the white screw cap and through the transparent bracket.
5. Hand screw in place with a screw driver. Do not over-tighten!
Using a drill in this step or overtightening can put too much pressure from the metal screw on the bracket and cause shattering. This is not a fault and no refunds will be provided due to incorrect installation.
Ensure board slides easily in and out by rotating the side brackets 90° to release the board.